Cisco Cisco Packet Data Gateway (PDG)
max-retransmission
This command configures the retransmission values for different procedure counters in Gs service as described
in TS 29.018.
in TS 29.018.
Product
SGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > Gs Service Configuration
configure > context context_name > gs-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-gs-service)#
Syntax Description
max-retransmissions { n8 | n9 | n10 | n12 } retrans_num
default max-retransmissions { n8 | n9 | n10 | n12 }
default max-retransmissions { n8 | n9 | n10 | n12 }
no
Removes the configured Gs procedures from this Gs service.
{ n8 | n9 | n10 | n12 }
Specifies the various Gs service procedures that are available to be used to communicate with VLR(s).
• n8: Defines the maximum number of retries for explicit IMSI detach from a non-GPRS service. Default
is 2.
• n9: Defines the maximum number of retries for explicit IMSI detach from a non-GPRS service. Default
is 2.
• n10: Defines the maximum number of retries for implicit IMSI detach from the GPRS service. Default
is 2.
• n12: Defines the maximum number of retries for BSSAP+ to send Reset Indication messages. Default
is 2.
retrans_num
Default: 2
Specifies the number of re-transmission of message for specified procedures.
Command Line Interface Reference, Modes G - H, StarOS Release 19
1044
Gs Service Configuration Mode Commands
max-retransmission