Cisco Cisco Packet Data Gateway (PDG)
authorize-with-hss
This command enables or disables subscriber session authorization via a Home Subscriber Server (HSS) over
an S6b Diameter interface. This feature is required to support the interworking of GGSN with P-GW and HA.
an S6b Diameter interface. This feature is required to support the interworking of GGSN with P-GW and HA.
Product
GGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > GGSN Service Configuration
configure > context context_name > ggsn-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ggsn-service)#
Syntax Description
authorize-with-hss [ report-ipv6-addr ]
{ default | no } authorize-with-hss
{ default | no } authorize-with-hss
default
Disables the default authorization of subscriber over S6b interface. Resets the command to the default setting
of "authorize locally" from an internal APN authorization configuration.
of "authorize locally" from an internal APN authorization configuration.
no
Disables the default authorization of subscriber over S6b interface. Resets the command to the default setting
of "authorize locally" from an internal APN authorization configuration.
of "authorize locally" from an internal APN authorization configuration.
report-ipv6-addr
Enables IPv6 address reporting through Authorization-Authentication-Request (AAR) towards the S6b
interface.
interface.
Usage Guidelines
Use this command to enable/disable the authorization support for subscriber over S6b interface, which is used
between GGSN and the 3GPP AAA to exchange the information related to charging, P-CSCF discovery, etc.
between GGSN and the 3GPP AAA to exchange the information related to charging, P-CSCF discovery, etc.
Use of this feature allows the GGSN service to interact with HSS over S6b interface through Diameter
configuration which is already configured on the system.
configuration which is already configured on the system.
Command Line Interface Reference, Modes G - H, StarOS Release 19
7
GGSN Service Configuration Mode Commands
authorize-with-hss