Cisco Cisco Packet Data Gateway (PDG)
threshold asngw-max-eap-retry
Configures alarm or alert thresholds for maximum retries for Extensible Authentication Protocol (EAP)
authentication within an ASN-GW service.
authentication within an ASN-GW service.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold asngw-max-eap-retry high_thresh [ clear low_thresh ]
default threshold asngw-max-eap-retry
default threshold asngw-max-eap-retry
high_thresh
Default: 0
Specifies the high threshold number of retries for EAP authentication that must be met or exceeded within
the polling interval to generate an alert or alarm.
the polling interval to generate an alert or alarm.
high_thresh is an integer from 0 through 10000000. A value of 0 disables the threshold.
clear low_thresh
Default: 0
Specifies the low threshold number of retries for EAP authentication that maintains a previously generated
alarm condition. If the number of retries falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
alarm condition. If the number of retries falls beneath the low threshold within the polling interval, a clear
alarm will be generated.
low_thresh is an integer from 0 through 10000000. A value of 0 disables the threshold.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Command Line Interface Reference, Modes G - H, StarOS Release 19
453
Global Configuration Mode Commands (T-threshold phspc)
threshold asngw-max-eap-retry