Cisco Cisco Packet Data Gateway (PDG)
echo-retransmission-timeout
Configures the timeout for GTPv1 echo message retransmissions for this service.
Product
GGSN
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration > GGSN Service Configuration
configure > context context_name > ggsn-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ggsn-service)#
Syntax Description
echo-retransmission-timeout seconds
default echo-retransmission-timeout
default echo-retransmission-timeout
default
Returns the command to its default setting of 3.
seconds
Default: 5
Configures the echo retransmission timeout, in seconds, for the GTPv1 service as an integer ranging from 1
to 20.
to 20.
Usage Guidelines
Use this command to configure the amount of time, in seconds, before the GTPv1 service transmits another
echo request message. The value set in this command is used, as is, for the default echo. If dynamic echo is
enabled (echo-interval dynamic) the value set in this command serves as the dynamic minimum (if the RTT
multiplied by the smooth factor is less than the value set in this command, the service uses this value).
echo request message. The value set in this command is used, as is, for the default echo. If dynamic echo is
enabled (echo-interval dynamic) the value set in this command serves as the dynamic minimum (if the RTT
multiplied by the smooth factor is less than the value set in this command, the service uses this value).
Examples
The following command sets the retransmission timeout for echo messages to 2 seconds:
echo-retransmission-timeout 2
echo-retransmission-timeout 2
Command Line Interface Reference, Modes G - H, StarOS Release 19
22
GGSN Service Configuration Mode Commands
echo-retransmission-timeout