Cisco Cisco Packet Data Gateway (PDG)
threshold phsgw-network-entry-denial
Configures, alarm or alert thresholds for the number of network entry denials in PHSGW.
Product
PHSGW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold phsgww-max-network-entry-denial high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of network entry denials for any one PHSGW service. This number must
be met or exceeded within the polling interval to generate an alert or alarm.
be met or exceeded within the polling interval to generate an alert or alarm.
high_thresh is an integer from 0 through 1000000. A value of 0 disables the threshold.
clear low_thresh
Default: 0
Specifies the low threshold number of network entry denials for any one PHSGW service. This number must
be met or exceeded to maintain a previously generated alarm condition. If the number of subscribers falls
beneath the low threshold within the polling interval, a clear alarm will be generated.
be met or exceeded to maintain a previously generated alarm condition. If the number of subscribers falls
beneath the low threshold within the polling interval, a clear alarm will be generated.
low_thresh is an integer from 0 through 1000000. A value of 0 disables the threshold.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Usage Guidelines
Set the monitoring and clearing thresholds for PHSGW network entry denials.
Alerts or alarms are triggered for handoff denials based on the following rules:
Command Line Interface Reference, Modes G - H, StarOS Release 19
598
Global Configuration Mode Commands (T-threshold phspc)
threshold phsgw-network-entry-denial