Cisco Cisco Packet Data Gateway (PDG)
threshold ppp-setup-fail-rate
Configures alarm or alert thresholds for the percentage of point-to-point protocol (PPP) setup failures.
Product
PDSN
GGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold ppp-setup-fail-rate high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold rate percentage for PPP setup failures experienced by the system that must be
met or exceeded within the polling interval to generate an alert or alarm.
met or exceeded within the polling interval to generate an alert or alarm.
high_thresh is an integer from 0 through 100. A value of 0 disables the threshold.
clear low_thresh
Default: 0
Specifies the low threshold rate percentage for PPP setup failures experienced by the system that maintains
a previously generated alarm condition. If the number of setup failures falls beneath the low threshold within
the polling interval, a clear alarm will be generated.
a previously generated alarm condition. If the number of setup failures falls beneath the low threshold within
the polling interval, a clear alarm will be generated.
low_thresh is an integer from 0 through 100. A value of 0 disables the threshold.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Command Line Interface Reference, Modes G - H, StarOS Release 19
897
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
threshold ppp-setup-fail-rate