Cisco Cisco Packet Data Gateway (PDG)
threshold total-sgsn-sessions
Configures alarm or alert thresholds for the total number of SGSN sessions in the system.
Product
SGSN
Privilege
Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold total-sgsn-sessions high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of total SGSN sessions for all SGSN services that must be met or exceeded
within the polling interval to generate an alert or alarm.
within the polling interval to generate an alert or alarm.
high_thresh is an integer from 1 through 2000000. A value of 0 disables the threshold.
clear low_thresh
Default: 0
Specifies the low threshold number of total SGSN sessions for all SGSN services that maintains a previously
generated alarm condition. If the number of sessions falls beneath the low threshold within the polling interval,
a clear alarm will be generated.
generated alarm condition. If the number of sessions falls beneath the low threshold within the polling interval,
a clear alarm will be generated.
low_thresh is an integer from 0 through 2000000. A value of 0 disables the threshold.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Usage Guidelines
Monitor and set alarms or alerts when the total number of SGSN sessions in the system is equal to or greater
than the set limit.
than the set limit.
Command Line Interface Reference, Modes G - H, StarOS Release 19
948
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
threshold total-sgsn-sessions