Cisco Cisco Packet Data Gateway (PDG)

This command configures the Diameter credit control primary and secondary hosts for DCCA.

All

Security Administrator, Administrator

Exec > ACS Configuration > Credit Control Configuration

active-charging service service_name > credit-control

Entering the above command sequence results in the following prompt:

[local]

(config-dcca)#

In 8.x and earlier releases:

diameter peer-select peer peer_name [ realm realm_name ] [ secondary-peer secondary_peer_name [
realm realm_name ] ] [ imsi-based start-value imsi_start_value end-value imsi_end_value ]
no diameter peer-select [ imsi-based start-value imsi_start_value end-value imsi_end_value ]
In 9.0 and later releases, for UMTS deployments:

diameter peer-select peer peer_name [ realm realm_name ] [ secondary-peer secondary_peer_name [
realm realm_name ] ] [ imsi-based { { prefix | suffix } imsi/prefix/suffix_start_value } [ to
imsi/prefix/suffix_end_value ] ] [ msisdn-based { { prefix | suffix } msisdn-based/prefix/suffix_start_value }

[ to msisdn-based/prefix/suffix_end_value ] ]

no diameter peer-select [ imsi-based { { prefix | suffix } imsi/prefix/suffix_start_value } [ to
imsi/prefix/suffix_end_value ] ] | [ msisdn-based { { prefix | suffix } msisdn-based/prefix/suffix_start_value

} [ to msisdn-based/prefix/suffix_end_value ] ]

Removes previously configured Diameter credit control peer selection setting.

Specifies the primary host name. as an alphanumeric string of 1 through 63 characters that can contain
punctuation characters.

imsi-based start-value imsi_start_value end-value imsi_end_value

This section applies only to 8.3 and earlier releases.