Cisco Cisco Packet Data Gateway (PDG)
set
Configures parameters for the dynamic crypto map.
Product
ePDG
FA
GGSN
HA
HeNBGW
HNBGW
HSGW
MME
P-GW
PDSN
S-GW
SAEGW
SCM
SecGW
SGSN
Privilege
Security Administrator
Command Modes
Exec > Global Configuration > Context Configuration > Crypto Map IPSec IKEv1 Configuration
configure > context context_name > crypto map policy_name ipsec-ikev1
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-crypto-map)#
Syntax Description
set { bgp peer_address | control-dont-fragment { clear-bit | copy-bit | set-bit } | ikev1 natt [ keepalive
sec ] | ip mtu bytes | ipv6 mtu bytes | mode { aggressive | main } | peer peer_address | pfs { group1 | group2
| group5 } | phase1-idtype { id-key-id | ipv4-address [ mode { aggressive | main } ] | phase2-idtype {
ipv4-address | ipv4-address-subnet } | security-association lifetime { disable-phase2-rekey | keepalive |
kilo-bytes kbytes | seconds secs } transform-set transform_name [ transform-set transform_name2 ...
transform-set transform_name6 ]
sec ] | ip mtu bytes | ipv6 mtu bytes | mode { aggressive | main } | peer peer_address | pfs { group1 | group2
| group5 } | phase1-idtype { id-key-id | ipv4-address [ mode { aggressive | main } ] | phase2-idtype {
ipv4-address | ipv4-address-subnet } | security-association lifetime { disable-phase2-rekey | keepalive |
kilo-bytes kbytes | seconds secs } transform-set transform_name [ transform-set transform_name2 ...
transform-set transform_name6 ]
Command Line Interface Reference, Modes C - D, StarOS Release 19
1174
Crypto Map IPSec IKEv1 Configuration Mode Commands
set