Cisco Cisco Packet Data Gateway (PDG)
attach imei-query-type
Defines device Attach limitations for this call control profile if an IMEI is not already present in the Attach
Request.
Request.
Product
MME
SGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-call-control-profile-
profile_name
)#
Syntax Description
attach imei-query-type { imei | imei-sv | none } [ verify-equipment-identity [ allow-on-eca-timeout |
deny-greylisted | deny-unknown | verify-emergency ] + ]
remove attach imei-query-type
deny-greylisted | deny-unknown | verify-emergency ] + ]
remove attach imei-query-type
remove
Deletes the specified attach configuration.
imei-query-type { imei | imei-sv | none }
Configures system behavior during Attach procedures if an IMEI is not already present in the Attach Request.
• imei: Specifies that the system is required to query the UE for its International Mobile Equipment Identity
(IMEI).
• imei-sv: Specifies that the system is required to query the UE for its International Mobile Equipment
Identity - Software Version (IMEI-SV).
• none: Specifies that the system does not need to query for IMEI or IMEI-SV.
verify-equipment-identity [ allow-on-eca-timeout | deny-greylisted | deny-unknown | verify-emergency
]
]
Specifies that the identification (IMEI or IMEI-SV) of the UE is to be performed by the Equipment Identity
Register (EIR) over the S13 interface.
Register (EIR) over the S13 interface.
Command Line Interface Reference, Modes C - D, StarOS Release 19
28
Call Control Profile Configuration Mode
attach imei-query-type