Cisco Cisco Packet Data Gateway (PDG)
radius probe-message
This command configures the service ip-address to be sent as an AVP in RADIUS authentication probe
messages.
messages.
Product
All products supporting Inter chassis Session Recovery (ICSR)
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx)#
Syntax Description
radius probe-message local-service-address ipv4/ipv6_address
no radius probe-message local-service-address
no radius probe-message local-service-address
no
Disables sending of AVPs configured under probe-message cli in RADIUS authentication probe messages.
radius probe-message local-service-address
radius probe-message
Configures AVPs to be sent in RADIUS authentication probe messages.
local-service-address
Configures the service ip-address to be sent as an AVP in RADIUS authentication probe messages.
ipv4/ipv6_address
Specifies the IPv4/IPv6 address of the server in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal
notation. A maximum of 128 RADIUS servers can be configured per context. This limit includes accounting
and authentication servers.
notation. A maximum of 128 RADIUS servers can be configured per context. This limit includes accounting
and authentication servers.
Examples
The following command configures the service ip-address 21.32.36.25 to be sent as an AVP in RADIUS
authentication probe messages:
authentication probe messages:
radius probe-message local-service-address 21.32.36.25
Command Line Interface Reference, Modes C - D, StarOS Release 19
920
Context Configuration Mode Commands N-R
radius probe-message