Cisco Cisco Packet Data Gateway (PDG)
neighbor
Configures OSPF routers that interconnect to non-broadcast networks.
Product
PDSN
HA
GGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > OSPF Configuration > OSPF VRF Configuration
configure > context context_name > router ospf > ip vrf vrf_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-ospf-vrf)#
Syntax Description
[
no
]
neighbor ip_address
[
poll-interval poll_interval_value
] [
priority priority_value
]
no
Disables OSPF routers that interconnect to non-broadcast networks.
ip_address
Specifies the interface IP address of the OSPF neighbor expressed using IPv4 dotted-decimal notation.
poll-interval poll_interval_value
Default: 120
Sets the number of seconds in the dead neighbor polling interval as an integer from 1 through 65535
priority priority_value
Default: 0
Sets the 8-bit number that represents the router priority value of the non-broadcast neighbor associated with
the specified IP address. This must be an integer from 0 through 255. This keyword does not apply to
point-to-multipoint interfaces.
the specified IP address. This must be an integer from 0 through 255. This keyword does not apply to
point-to-multipoint interfaces.
Usage Guidelines
Use this command to configure OSPF routers that connect to non-broadcast networks.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1188
OSPF VRF Configuration Mode Commands
neighbor