Cisco Cisco Packet Data Gateway (PDG)

policy-control

This command enters the PCP Policy Control Configuration mode to configure policy control parameters for
PCP service.

This command is customer specific. For more information, contact your Cisco account representative.

Important

Product

ACS

NAT

PSF

Privilege

Security Administrator, Administrator

Command Modes

Exec > ACS Configuration > Port Control Protocol Service Configuration

active-charging service service_name > pcp-service service_name

Entering the above command sequence results in the following prompt:

[local]

host_name

(config-pcp-service)#

Syntax Description

[ default ] policy-control

default

Configures this command with the default setting.

Default: Enabled

Usage Guidelines

Use this command to enter the PCP Policy Control Configuration Mode to configure the policy control
parameters for the PCP service.

On entering this command, the CLI prompt changes to:

[context_name]hostname(config-pcp-policy-control)#

Also see the PCP Policy Control Configuration Mode Commands chapter.

Command Line Interface Reference, Modes I - Q, StarOS Release 19

1476

PCP Configuration Mode Commands

policy-control