Cisco Cisco Packet Data Gateway (PDG)
condition
This command is used to configure the conditions which trigger the ruledef event.
Product
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Local Policy Service Configuration > Local Policy Ruledef Configuration
configure > local-policy-service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-local-policy-ruledef)#
Syntax Description
condition priority priority { variable { eq | ge | gt | le | lt | match | ne | nomatch } regex | string_value |
int_value | set }
no condition priority priority
int_value | set }
no condition priority priority
priority priority
Specifies a priority for the specified condition.
priority must be unique and an integer from 1 to 2048.
variable
The following variables are supported:
• apn
The APN associated with the current session expressed as an alphanumeric string of 1 through 63
characters.
characters.
• arp
The ARP value associated with the current session expressed as an integer from 1 through 15.
• bandwidth
Total bandwidth associated with the QCI and ARP value associated with the request, expressed as an
integer from 0 through 1000000000.
integer from 0 through 1000000000.
• bsid
Command Line Interface Reference, Modes I - Q, StarOS Release 19
526
Local Policy Ruledef Configuration Mode Commands
condition