Cisco Cisco Packet Data Gateway (PDG)
bind
Binds the service to a logical IP interface serving as the SGs interface.
Product
MME
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration > MME SGs Service Configuration
configure > context context_name > sgs-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-sgs-service)#
Syntax Description
bind { ipv4-address ipv4_address [ ipv4-address ipv4_address ] | ipv6-address ipv6_address [ ipv6-address
ipv6_address ] }
no bind
no bind
Removes the interface binding from this service.
ipv4-address ipv4_address [ ipv4-address ipv4_address ]
Specifies the IP address of the SGs interface in IPv4 dotted-decimal notation. n.
A secondary IPv4 address can be configured to support SCTP multi-homing.
ipv6-address ipv6_address [ ipv6-address ipv6_address ]
Specifies the IP address of the SGs interface in IPv6 colon-separated-hexadecimal notation.
A secondary IPv6 address can be configured to support SCTP multi-homing.
Usage Guidelines
Associate the SGs service to a specific logical IP address. The logical IP address or interface takes on the
characteristics of an SGs interface that provides the session connectivity for circuit switched fallback (CSFB)
to/from a Mobile Switching Center/Visitor Location Register (MSC/VLR). Only one interface can be bound
to a service. The interface should be configured prior to issuing this command
characteristics of an SGs interface that provides the session connectivity for circuit switched fallback (CSFB)
to/from a Mobile Switching Center/Visitor Location Register (MSC/VLR). Only one interface can be bound
to a service. The interface should be configured prior to issuing this command
Command Line Interface Reference, Modes I - Q, StarOS Release 19
830
MME SGs Service Configuration Mode Commands
bind