Cisco Cisco Packet Data Gateway (PDG)
reauth-trigger
This command specifies the trigger events to initiate re-authorization for a subscriber in IMS authorization
service.
service.
This command now moved to Policy Control Config mode.
Important
Product
All
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > IMS Authorization Service Configuration
configure > context context_name > ims-auth-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-imsa-service)#
Syntax Description
[ default ] reauth-trigger { all | { an-gw-change | bearer-loss | bearer-recovery | plmn-change |
policy-failure | qos-change | rat-change | sgsn-change | tft-change | tft-delete } + }
policy-failure | qos-change | rat-change | sgsn-change | tft-change | tft-delete } + }
Default
Sets the pre-configured Re-authorization trigger to default value.
all
Sets the IMS authorization service to initiate re-authorization process for a subscriber on all events listed in
this command.
this command.
an-gw-change
Sets the IMS authorization service to initiate re-authorization process for a subscriber whose access network
gateway changed.
gateway changed.
bearer-loss
Sets the IMS authorization service to initiate re-authorization process for a subscriber on loss of bearer or
service.
service.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
53
IMS Authorization Service Configuration Mode Commands
reauth-trigger