Cisco Cisco Packet Data Gateway (PDG)
peer-sgsn rai
Statically configures Routing Area Identity (RAI) parameters of the peer SGSN environment to facilitate
MME-SGSN relocations over S3 or Gn/Gp interfaces.
MME-SGSN relocations over S3 or Gn/Gp interfaces.
Product
MME
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-mme-service)#
Syntax Description
peer-sgsn rai mcc mcc_value mnc mnc_value [ nri value ] rac value lac value address ip_address capability
[ gn ] [ gp ] [ s16 ] [ s3 ]
no peer-sgsn rai mcc mcc_value mnc mnc_value [ nri value ] rac value lac value
no
Deletes the specified peer-SGSN RAI parameter configuration from the MME Service configuration.
mcc mcc_value
Specifies the mobile country code (MCC) portion of the PLMN identifier as an integer from 100 through 999.
mnc mnc_value
Specifies the mobile network code (MNC) portion of the PLMN identifier as a 2- or 3-digit integer from 00
through 999.
through 999.
nri value
Specifies the Network Resource Identifier (NRI) value, used as an additional identity, as an integer from 0
through 65535.
through 65535.
rac value
Specifies the Routing Area Code (RAC) used to facilitate a lookup for a specific peer SGSN as an integer
from 0 through 255.
from 0 through 255.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
951
MME Service Configuration Mode Commands
peer-sgsn rai