Cisco Cisco Packet Data Gateway (PDG)
multiple-reg
Specifies the number of simultaneous Mobile IP sessions that will be supported for over a single PPP session.
Product
PDSN
ASN-GW
GGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > FA Service Configuration
configure > context context_name > fa-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-fa-service)#
Syntax Description
multiple-reg number
number
number can be configured to an integer from 1 through 3.
Usage Guidelines
Use to support multiple registrations per subscriber.
The system defaults to a setting of "1" for multiple simultaneous MIP sessions.
The system will only support multiple Mobile IP sessions per subscriber if the subscriber's mobile node
has a static IP address. The system will only allow a single Mobile IP session for mobile nodes that receive
a dynamically assigned IP address. In addition, because only a single Mobile IP or proxy-Mobile IP session
is supported for IP PDP contexts, this parameter must remain at its default configuration.
has a static IP address. The system will only allow a single Mobile IP session for mobile nodes that receive
a dynamically assigned IP address. In addition, because only a single Mobile IP or proxy-Mobile IP session
is supported for IP PDP contexts, this parameter must remain at its default configuration.
Important
Examples
The following command configures the number of supported simultaneous registrations for subscribers using
this FA service to 3.
multiple-reg 3
this FA service to 3.
multiple-reg 3
Command Line Interface Reference, Modes E - F, StarOS Release 19
1636
FA Service Configuration Mode Commands
multiple-reg