Cisco Cisco Packet Data Gateway (PDG)
firewall tcp-partial-connection-timeout
This command configures action on idle timeout for partially open TCP connections.
Product
PSF
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Firewall-and-NAT Policy Configuration
active-charging service service_name > fw-and-nat policy policy_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-fw-and-nat-policy)#
Syntax Description
firewall tcp-partial-connection-timeout timeout
{ default | no } firewall tcp-partial-connection-timeout
{ default | no } firewall tcp-partial-connection-timeout
default
Configures the default setting.
no
Disables the idle timeout for partially open TCP connections.
timeout
Specifies the timeout in seconds.
timeout must be an integer from 0 through 86400.
Default: 30 seconds
Usage Guidelines
Use this command to configure idle timeout for TCP connections that are yet to be established (partially open)
in the case of Firewall enabled calls.
in the case of Firewall enabled calls.
Examples
The following command sets the idle timeout setting to 30 seconds:
firewall tcp-partial-connection-timeout 30
firewall tcp-partial-connection-timeout 30
Command Line Interface Reference, Modes E - F, StarOS Release 19
1709
Firewall-and-NAT Policy Configuration Mode Commands
firewall tcp-partial-connection-timeout