Cisco Cisco Packet Data Gateway (PDG)
nat icsr-flow-recovery
This command enables/disables the NAT ICSR Flow checkpointing support for subscribers in a
Firewall-and-NAT policy. This command is deprecated in StarOS 14.0 and later releases, and is replaced by
the nat check-point-info command.
Firewall-and-NAT policy. This command is deprecated in StarOS 14.0 and later releases, and is replaced by
the nat check-point-info command.
Product
NAT
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Firewall-and-NAT Policy Configuration
active-charging service service_name > fw-and-nat policy policy_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-fw-and-nat-policy)#
Syntax Description
[ default | no ] nat icsr-flow-recovery
default
Configures the default setting.
Default: Disabled. Same as no icsr-flow-recovery.
no
Disables the NAT ICSR Flow checkpointing.
Usage Guidelines
Use this command to enable/disable all NAT ICSR Flow checkpointing for subscribers using this policy.
Examples
The following command enables NAT ICSR Flow checkpointing:
nat icsr-flow-recovery
nat icsr-flow-recovery
Command Line Interface Reference, Modes E - F, StarOS Release 19
1721
Firewall-and-NAT Policy Configuration Mode Commands
nat icsr-flow-recovery