Cisco Cisco ASR 5000
ACS Rulebase Configuration Mode Commands
▀ route priority
▄ Command Line Interface Reference, StarOS Release 18
768
Analyzer
Common ways to route to the analyzer
tcp
All IPv4 packets with IP protocol = TCP (6) are automatically routed here.
udp
All IPv4 packets with IP protocol = UDP (17) are automatically routed here.
wap2
TCP destination port or source port of the carrier-specific port number for WAP-2 (e.g. one carrier uses 8799); or,
send all HTTP traffic to the wap2 analyzer if the carrier does not use a special port number.
send all HTTP traffic to the wap2 analyzer if the carrier does not use a special port number.
wsp
UDP destination port or source port is connection-less WSP (9200) or connection-oriented WSP (9201).
wtp
Packets are automatically routed here, if you specified “wsp-connection-oriented” as described above.
Example
The following command assigns a route and rule action with the route priority of 23, a ruledef named
test
,
and an analyzer
test_analyzer
with description as
route_test1
to the current rulebase:
route priority 23 ruledef test analyzer test_analyzer description
route_test1
route_test1