Cisco Cisco Packet Data Gateway (PDG)
Context Configuration Mode Commands E-H
▀ gtpp echo-interval
▄ Command Line Interface Reference, StarOS Release 18
2478
gtpp echo-interval
Configures the frequency at which the system sends GTPP echo packets to configured CGFs.
Product
GGSN
SGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
gtpp echo-interval time
{ default | no } gtpp echo-interval
default
Configures the default setting for this command,
Default: 60 seconds
Default: 60 seconds
no
Disables the use of the echo protocol except for the scenarios described in the Usage section for this
command.
command.
time
Specifies the time interval (in seconds) for sending GTPP echo packets as an integer from 60 through
2147483647. Default: 60
2147483647. Default: 60
Usage
The GTPP echo protocol is used by the system to ensure that it can communicate with configured CGFs. The
system initiates this protocol for each of the following scenarios:
system initiates this protocol for each of the following scenarios:
Upon system boot
Upon the configuration of a new CGF server on the system using the gtpp server command as
described in this chapter
Upon the execution of the
gtpp test accounting
command as described in the Exec Mode
Commands chapter of this reference