Cisco Cisco Packet Data Gateway (PDG)
CSCF Peer Server Monitoring Configuration Mode Commands
▀ dummy-as
▄ Command Line Interface Reference, StarOS Release 18
3194
dummy-as
Sets a response code for Dummy-AS peer server.
Product
SCM (S-CSCF)
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > CSCF Peer Servers Configuration > Server Configuration
configure > context context_name > cscf peer-servers server_name type { bgcf | ibcf |
icscf | mgcf | mrcf | pcscf | scscf | sip-as } > server server_name { address ip_address
| domain domain_name )
icscf | mgcf | mrcf | pcscf | scscf | sip-as } > server server_name { address ip_address
| domain domain_name )
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-server_name-peer-server)#
Syntax
dummy-as custom-response-code SIP_response_code
default dummy-as custom-response-code
custom-response-code
SIP_response_code
If the peer server is configured as dummy-as and it is chosen as per routing table configured, a UMM
response message will be formed with the response code configured and sent as reply to incoming
MESSAGE/PUBLISH requests.
response message will be formed with the response code configured and sent as reply to incoming
MESSAGE/PUBLISH requests.
SIP_response_code
must be an integer from 200 to 699.
Important:
The response code can be 2xx/4xx/5xx/6xx; 3xx,401,and 407 are not allowed.
default dummy-as custom-response-code
Sets the response code to 200.
Usage
Use this command to configure a response code for Dummy-AS. If this mode is selected, then
MESSAGE/PUBLISH requests will be responded to by S-CSCF with configured response code.
MESSAGE/PUBLISH requests will be responded to by S-CSCF with configured response code.
Example
The following command configures AS as Dummy-AS with a corresponding response code of
425
:
dummy-as custom-response-code 425