Cisco Cisco Packet Data Gateway (PDG)
Exec Mode Commands (D-S)
statistics-collection ▀
Command Line Interface Reference, StarOS Release 18 ▄
4245
statistics-collection
This command allows to dynamically enable collection of Charging, Firewall or Post-processing ruledef statistics.
Product
ACS
Privilege
Security Administrator, Administrator, Operator, Inspector
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
statistics-collection active-charging { { all | charging | firewall | post-processing } {
callid call_id | imsi imsi_number } }
callid call_id | imsi imsi_number } }
[ no ] statistics-collection active-charging { callid call_id | imsi imsi_number }
no
If previously configured, deletes the specified rule expression from the current ruledef.
all | charging | firewall | post-processing
all
: Specifies to collect all ruledef statistics.
charging
: Specifies to collect charging ruledef statistics.
firewall
: Specifies to collect firewall ruledef statistics.
post-processing
: Specifies to collect post-processing ruledef statistics.
callid call_id
Specifies a call identification number as an eight-byte hexadecimal number.
imsi imsi_number
Specifies the IMSI number to match.
imsi_number
must be a sequence of digits.
Usage
Use this command to dynamically enable collection of ruledef statistics — Charging, Firewall or Post-
processing. By default, the statistics will not be maintained. If the command is not configured, statistics
collection will not be enabled and the following error message will be displayed in the
processing. By default, the statistics will not be maintained. If the command is not configured, statistics
collection will not be enabled and the following error message will be displayed in the
show active-
charging sessions full
CLI — “statistics collection disabled; not collecting
<charging/firewall/postprocessing> ruledef stats”.