Cisco Cisco Packet Data Gateway (PDG)
GGSN Service Configuration Mode Commands
▀ associate peer-map
▄ Command Line Interface Reference, StarOS Release 18
5214
associate peer-map
This command associates a previously configured GGSN peer-map in LTE Policy Configuration mode with GGSN
service. A peer-map must be configured before using this configuration.
service. A peer-map must be configured before using this configuration.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > GGSN Service Configuration
configure > context context_name > ggsn-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ggsn-service)#
Syntax
associate peer-map peer_map_name
no associate peer-map
no
Removes the associated Peer-Map from this GGSN service configuration.
peer_map_name
Identifies the name of the Peer Map preconfigured in LTE-Policy Configuration mode to associate with a
GGSN service.
GGSN service.
peer_map_name
is an alphanumeric string from 1 through 63 characters.
Usage
Use this command to associate Peer Map with GGSN service. The peer-profile associated with peer map can
be configured in GGSN Peer-Profile configuration mode.
be configured in GGSN Peer-Profile configuration mode.
Important:
When there is no association of peer-map in any of the service, then “default” peer profile of the
corresponding service-interface type shall be applied except for GTP-C parameters. Also GTP-C parameters
configuration shall be applied from GG service level configuration for GGSN. A maximum of 1024 peer map rules can
be configured on one system.
configuration shall be applied from GG service level configuration for GGSN. A maximum of 1024 peer map rules can
be configured on one system.
Example
Following command associates Peer Map named
ggsn_peer_map1
with specific GGSN service.
associate peer-map ggsn_peer_map1