Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (A-K)
▀ congestion-control overload-disconnect
▄ Command Line Interface Reference, StarOS Release 18
5338
congestion-control overload-disconnect
This command enables and disables the policy for disconnecting passive calls (chassis-wide) during an overload
situation. It also configures and fine-tunes the overload-disconnect congestion control policy for an entire chassis.
situation. It also configures and fine-tunes the overload-disconnect congestion control policy for an entire chassis.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
congestion-control overload-disconnect [ iterations-per-stage integer | percent
percentage_value | threshold { license-utilization percentage_value | max-sessions-per-
service-utilization percentage_value | tolerance number } ]
percentage_value | threshold { license-utilization percentage_value | max-sessions-per-
service-utilization percentage_value | tolerance number } ]
default congestion-control overload-disconnect [ iterations-per-stage | percent |
threshold { license-utilization | max-sessions-per-service-utilization | tolerance } ]
threshold { license-utilization | max-sessions-per-service-utilization | tolerance } ]
no congestion-control overload-disconnect
default
When “default” and one of the keywords is added to the command, the policy remains in its current state and
the value for the specified keyword is reset to its default value.
When “default” and the command are entered without keywords, the overload-disconnect policy for
congestion control is disabled.
the value for the specified keyword is reset to its default value.
When “default” and the command are entered without keywords, the overload-disconnect policy for
congestion control is disabled.
no
Disables the overload-disconnect policy for congestion control.
iterations-per-stage integer
Specifies the number of calls to be disconnected during the defined number of seconds.
integer
is a value
from 2 through 8. The default value is 8.
percent percentage_value
Specifies the percentage of calls to be disconnected, in stages, during an overload situation.
percentage_value
is an integer from 1 through 100. The default value is 5.