Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (A-K)
▀ hd raid
▄ Command Line Interface Reference, StarOS Release 18
5420
hd raid
Performs RAID management operations on the platform’s hard disk drives.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
For the ASR 5000:
hd raid { check | create | insert | overwrite | remove | select } {
local1 | remote1 } [ -force ] [ -noconfirm ]
local1 | remote1 } [ -force ] [ -noconfirm ]
For the ASR 5500:
hd raid { check | create | insert | overwrite | remove | select } hd_num
[ -force ] [ -noconfirm ]
[ -force ] [ -noconfirm ]
For VPC:
hd raid { check | create | insert | overwrite | remove | select } { |
local1 | local2 } [ -force ] [ -noconfirm ]
local1 | local2 } [ -force ] [ -noconfirm ]
check
Starts a background check on RAID disks unless the RAID is running in degraded mode.
create { local1 | remote 1 }
On the ASR 5000, creates a new RAID that could run in degraded mode on the specified drive:
local1
specifies the RAID is to be established on the primary SMC.
remote1
specifies the RAID is to be
established on the backup SMC.
create
hd_num
On the ASR 5500, creates a new RAID that could run in degraded mode on the hard drive array of a specific
FSC.
FSC.
hd_num
specifies the RAID is to be established on the FSC in slot numbers 13 through 18 (hd13, hd14, ...
hd18).
create
{ local1 | local2 }
On VPC, creates a new virtual RAID as vHD local1 or vHD local2.