Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (threshold poll commands O - Z)
▀ threshold poll total-mme-sessions
▄ Command Line Interface Reference, StarOS Release 18
5936
threshold poll total-mme-sessions
Configures the polling interval over which to count or measure the thresholding value for MME sessions on the system.
Product
MME
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll total-mme-sessions interval time
default threshold poll total-mme-sessions interval
default
Restores the threshold poll interval value to its default value of 900 seconds.
interval
time
Default: 900 seconds
Specifies the polling interval (in seconds) for counting the total number of MME sessions on the system.
Specifies the polling interval (in seconds) for counting the total number of MME sessions on the system.
time
must be an ny integer from 30 through 60000.
Usage
This command sets the time period over which to monitor the specified value for threshold crossing.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold model
and
threshold monitoring
commands for additional information on the
system’s support for thresholding.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshMMESessions
command in this mode.
Example
The following command configures the polling interval for the total MME session threshold polling duration
value to
value to
600
seconds (10 minutes):
threshold poll total-mme-sessions interval 600