Cisco Cisco Packet Data Gateway (PDG)
HeNB-GW Access Service Configuration Mode Commands
▀ s1-mme sctp port
▄ Command Line Interface Reference, StarOS Release 18
6324
s1-mme sctp port
This command configures the local Stream Control Transmission Protocol (SCTP) port used for binding the SCTP
socket to communicate with the HeNBs over S1-MME interface.
socket to communicate with the HeNBs over S1-MME interface.
Product
HeNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HeNBGW-Access Service Configuration
configure > context context_name > henbgw-access-service
service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-henbgw-access-service)#
Syntax
s1-mme sctp port port_num
default s1-mme sctp port
default
Sets the SCTP port to the default value of 36412 to communicate with the HeNBs using S1-MME interface.
port_num
Specifies the SCTP port number to communicate with the HeNBs using S1-MME interface as an integer from
1 through 65535. Default: 36412
1 through 65535. Default: 36412
Usage
Use this command to assign the SCTP port with SCTP socket to communicate with the HeNB using S1AP.
Only one SCTP port can be associated with one MME service.
Only one SCTP port can be associated with one MME service.
Example
The following command sets the default SCTP port number 699 for to interact with Home eNodeB using
S1AP on S1-MME interface:
S1AP on S1-MME interface:
default s1-mme sctp port