Cisco Cisco Packet Data Gateway (PDG)
IPNE Endpoint Configuration Mode Commands
peer ▀
Command Line Interface Reference, StarOS Release 18 ▄
6637
peer
Identifies the MINE server as a peer for the IPNE endpoint.
Product
MME
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IPNE Service Configuration > IPNE Endpoint Configuration
configure > context context_name
> ipne-service
ipne_service_name > ipne-endpoint
Entering the above command sequence results in the following prompt:
[ context_name]host_name (config-ipne-endpoint)#
Syntax
[ no ] peer { ipv4-address | ipv6-address } ip_address
no
Removes the peer address from the IPNE endpoint configuration.
ipv4-address | ipv6-address
Informs the system of the format of the peer address.
ip_address
Enter either an IPv4 dotted-decimal address or an IPv6 colon-separated hexadecimal notation.
Usage
Use the
peer
command to configure a MINE server IP address as the peer for the IPNE endpoint.
Example
Enter an IPv4 address for the MINE server:
peer ipv4-address 221.221.221.1