Cisco Cisco Packet Data Gateway (PDG)
IPSG RADIUS Server Configuration Mode Commands
▀ gtp peer-ip-address
▄ Command Line Interface Reference, StarOS Release 18
6668
gtp peer-ip-address
This command allows you to configure GGSN IP address under the eWAG service.
Product
eWAG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IPSG RADIUS Server Configuration
configure > context context_name > ipsg-service service_name mode radius-server
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ipsg-service-radius-server)#
Syntax
gtp peer-ip-address ipv4_address
no gtp peer-ip-address
no
Deletes the configuration, if previously configured.
gtp peer-ip-address ipv4_address
Specifies the GGSN IP address.
ipv4_address
Usage
Use this command to configure the GGSN IP address under the eWAG service.
This command replaces the hidden mode command
This command replaces the hidden mode command
[ no ] ggsn-ip-address ipv4_address
Example
The following command configures the GGSN IP address
1.2.3.4
under the current eWAG service.
gtp peer-ip-address 1.2.3.4