Cisco Cisco Packet Data Gateway (PDG)
MRME Service Configuration Mode Commands
disconnect ▀
Command Line Interface Reference, StarOS Release 18 ▄
7457
disconnect
This command allows you to specify the delay duration before which the call is disconnected.
Product
SaMOG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > MRME Service Configuration
configure > context context_name > mrme-service
mrme_service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mrme-service)#
Syntax
disconnect { delay-time seconds | wait-time seconds }
default disconnect { delay-time | wait-time }
default
Configures this command to its default setting.
delay-time
default: 30 seconds
wait-time
default: 10 seconds
delay-time seconds
Specifies to configure the timer to retain the session on receiving an Accounting Stop, and for roaming
scenarios, session continuity on receiving an Accounting Start.
scenarios, session continuity on receiving an Accounting Start.
seconds
must be an integer from 1 through 60.
wait-time seconds
Specifies to configure the timer to wait for accounting start message from the new WLC after processing the
accounting stop message from the old WLC.
accounting stop message from the old WLC.
seconds
must be an integer of 10 through 300.
Usage
Specifies to configure the timer to wait for accounting stop message after triggering a Disconnect Req
Message to WLC for an SAMOG session.
Message to WLC for an SAMOG session.
Example
The following command sets the disconnect wait time to 60 seconds.
disconnect wait-time 60