Cisco Cisco Packet Data Gateway (PDG)
PCC-Action-Set Configuration Mode Commands
▀ rule-deactivate
▄ Command Line Interface Reference, StarOS Release 18
7658
rule-deactivate
This command sets an action to deactivate a pre-configured Rule in PCC-Action-Set configuration for PCC-Service
instance.
instance.
Product
IPCF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC Action-Set Configuration
configure > context context_name > pcc-service service_name > action-set action_set_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pcc-action-set)#
Syntax
[no] rule-deactivate rule_name [defer-by interval delayed_dur]
no
Removes the action to deactivate a pre-configured Rule from a PCC-Action-Set configuration instance for
PCC-Service configuration.
PCC-Service configuration.
rule_name
Specifies the name of the pre-configured Rule on PCEF for a deactivation action is set under PCC-Action-Set
configuration instance for PCC-Service configuration.
configuration instance for PCC-Service configuration.
rule_name
is a pre-configured Rule in PCEF.
defer-by
interval
delayed_dur
This optional keyword supports the time-of-day-based procedures under PCC-Action-Set instance by
configuring the relative time delay for rule deactivation.
configuring the relative time delay for rule deactivation.
delayed_dur
configures the relative delay time by which the corresponding rule deactivation is deferred.
The action is triggered only when the time specified by
delayed_dur
is passed.
delayed_dur
specifies the delayed interval in
HH
MIN
SS
format.
Following format is used for
HH
MIN
SS
in
delayed_dur
:
HH
specifies the hour to defer the action trigger and must be an integer between 00 through 23.
MIN
specifies the minutes to defer the action trigger and must be an integer between 00 through 59.
SS
specifies the seconds to defer the action trigger and must be an integer between 00 through 59.
Usage
Use this command to set an action to deactivate a pre-configured Rule in PCC-Action-Set configuration for
PCC-Service instance.
Additionally
PCC-Service instance.
Additionally
defer-by
interval
keyword is used to configure relative time by which the corresponding
rule deactivation is deferred.