Cisco Cisco Packet Data Gateway (PDG)
P-GW Service Configuration Mode Commands
▀ setup-timeout
▄ Command Line Interface Reference, StarOS Release 18
8072
setup-timeout
Configures the maximum amount of time the P-GW service takes for creating a session.
Product
P-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > P-GW Service Configuration
configure > context context_name > pgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pgw-service)#
Syntax
setup-timeout setup_time
default setup-timeout
default
Configures the default guard timer value for session creation.
setup-time
Default: 60
Specifies the maximum amount of time taken by P-GW for service creation.
Specifies the maximum amount of time taken by P-GW for service creation.
setup_time
is measured in seconds and can be configured to an integer from 1 through 120.
Usage
Use this command to limit the amount of time allowed for creating a session. If a “Create Session Request” is
received and the setup-timeout is configured, the timer starts with the configured value. If the setup timeout is
not configured, the timer starts with the default value of 60 seconds.
received and the setup-timeout is configured, the timer starts with the configured value. If the setup timeout is
not configured, the timer starts with the default value of 60 seconds.
Example
The following command allows a maximum of
120
seconds for creating a session:
setup-timeout 120