Cisco Cisco Packet Data Gateway (PDG)
S-GW Service Configuration Mode Commands
egtp-service ▀
Command Line Interface Reference, StarOS Release 18 ▄
8725
egtp-service
Configures an eGTP service to use as either an ingress (S1-U) or egress (S5/S8) service for the S-GW.
Product
S-GW
SAEGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > S-GW Service Configuration
configure > context context_name > sgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgw-service)#
Syntax
egtp-service { egress { context name | service name } | ingress service name }
no egtp-service { egress { context | service } | ingress service }
no
Removes the selected EGTP service from this service.
egress { context name | service name }
Specifies the egtp-service to be used as the egress eGTP service on a GTP-based S5/S8 interface.
context name
: Specifies the name of the context where the eGTP service resides.
name
must be an existing context name where an eGTP service resides expressed as an alphanumeric string
of 1 through 63 characters.
service name
: Specifies the name of the egress eGTP service.
name
must be an existing eGTP service name expressed as an alphanumeric string of 1 through 63 characters.
ingress service name
Specifies the egtp-service to be used as the ingress eGTP service on the S11 interface.
name
must be an existing eGTP service name expressed as an alphanumeric string of 1 through 63 characters.
Usage
Use this command to configure the eGTP service to use with this S-GW service. The eGTP service must be
existing and be configured with the appropriate parameters supporting the intended service type.
existing and be configured with the appropriate parameters supporting the intended service type.
Example
The following command configures the S-GW service to use an eGTP service named
s1u-egtp
as its ingress
service:
egtp-service ingress service slu-egtp