Cisco Cisco Packet Data Gateway (PDG)
SS7 Routing Domain Configuration Mode Commands
peer-server ▀
Command Line Interface Reference, StarOS Release 18 ▄
8773
peer-server
This command creates a peer-server instance to setup a SIGTRAN peer for sending and receiving M3UA traffic.
Completing the command automatically enters the peer- server configuration mode. To define 1 or more (up to 145)
peer servers, use the commands documented in the Peer-Server Configuration Mode chapter in this reference.
Completing the command automatically enters the peer- server configuration mode. To define 1 or more (up to 145)
peer servers, use the commands documented in the Peer-Server Configuration Mode chapter in this reference.
Product
SGSN
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > SS7 Routing Domain Configuration
configure > ss7-routing-domain routing_domain_id variant variant_type
Entering the above command sequence results in the following prompt:
[local]host_name(config-ss7-routing-domain-ss7rd_id)#
Syntax
peer-server id srvr_id
no peer-server id srvr_id
no
Removes the identified peer-server definition from the system configuration.
srvr_id
srvr_id
uniquely identifies a peer-server. The id must be an integer from 1 to 144. For SGSN Release 15.0,
the id must be an integer from 1 to 256.
Usage
Use the following command to create a definition for peer-server 2 and enter the configuration mode to
configure the communication parameters for peer-server 12.
configure the communication parameters for peer-server 12.
Example
peer-server id 12