Cisco Cisco Packet Data Gateway (PDG)

 

▄  Command Line Interface Reference, StarOS Release 18 

Configures the point-to-point protocol (PPP) options for the current subscriber. 

 

PDSN 

PDSN CLosed R-P 

GGSN 

 

Security Administrator, Administrator 

 

Exec > Global Configuration > Context Configuration > Subscriber Configuration 

configure > context context_name > subscriber { default | name subscriber_name }

 

Entering the above command sequence results in the following prompt: 

[context_name]host_name(config-subscriber)# 

 

ppp { accept-peer-ipv6-ifid | always-on-vse-packet | data-compression { mode { normal | 
stateless } | protocols { protocols [ protocols ] } | ip-header-compression negotiation { 
detect | force | vj compress-slot-id { both | none | receive | transmit } } | ipv4 { 
disable | enable | passive } | ipv6 { disable | enable | passive } | keepalive seconds | 
min-compression-size min_octets | mtu max_octets | remote-renegotiation disconnect { 
always | nai-prefix-msid-mismatch } } 

default ppp { accept-peer-ipv6-ifid | always-on-vse-packet | data-compression { mode | 
protocols } | ip-header-compression negotiation [ vj compress-slot-id ] | ipv4 | ipv6 | 
keepalive | min-compression-size | mtu | remote-renegotiation disconnect } 

no ppp { accept-peer-ipv6-ifid | always-on-vse-packet | data-compression protocols | ipv4 
| ipv6 | keepalive | mtu | remote-renegotiation disconnect } 

 

Restores the default value for the option specified. 

 

Resets the option specified to its default. 

 

Default: Enabled 
If this feature is enabled, the PDSN sends special 3GPP2 VSE PPP packets to the Mobile Node with a 
maximum inactivity timer value. This configuration is applicable only for PDSNsessions. 

 

Default: None