Cisco Cisco ASR 5700
IuPS Service Configuration Mode Commands
▀ blacklist-timeout-gtpu-bind-addresses
▄ Command Line Interface Reference, StarOS Release 17
6744
blacklist-timeout-gtpu-bind-addresses
This command specifies the time period that a GTP-U bind address (loopback address) will not be used (is blacklisted)
in RAB-Assignment requests after a RAB assignment request, with that GTP-U bind address, has been rejected by an
RNC with the cause - Unspecified Error. This is a failure at the RNC’s GTP-U IP interface.
in RAB-Assignment requests after a RAB assignment request, with that GTP-U bind address, has been rejected by an
RNC with the cause - Unspecified Error. This is a failure at the RNC’s GTP-U IP interface.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IuPS Service Configuration
configure > context context_name > iups-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx-iups-service)#
Syntax
blacklist-timeout-gtpu-bind-addresses seconds
default blacklist-timeout-gtpu-bind-addresses
default
Resets the blacklist time to 60 seconds.
seconds
Number of seconds that the GTP-U bind (loopback) address will not be used in a RAB-Assignment request.
seconds
: Must be an integer from 1 to 1800.
Usage
Use this command to configure the blacklist period.
Example
The following command specifies a 15 minutes (
460 seconds
) blacklist period.
blacklist-timeout-gtpu-bind-addresses 460