Cisco Cisco ASR 5700
IuPS Service Configuration Mode Commands
▀ network-sharing failure-code
▄ Command Line Interface Reference, StarOS Release 17
6762
network-sharing failure-code
Configure the reject cause code to included in network-sharing Reject messages.
Important:
With the release of 15.0, both 2G and 3G MOCN functionality is now license controlled and the
license is required to use all previously available network sharing SGSN configuration commands. For additional
information, contact your Cisco Account Representative.
information, contact your Cisco Account Representative.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IuPS Service Configuration
configure > context context_name > iups-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx-iups-service)#
Syntax
network-sharing failure failure_code
default network-sharing failure
default
Resets the SGSN service to use the default cause code,14 (GPRS services not allowed in this PLMN).
failure_code
Enter one of the GMM failure cause codes listed below (from section 10.5.5.14 of the 3GPP TS 124.008
v7.2.0 R7):
v7.2.0 R7):
2 - IMSI unknown in HLR
3 - Illegal MS
6 - Illegal ME
7 - GPRS services not allowed
8 - GPRS services and non-GPRS services not allowed
9 - MSID cannot be derived by the network
10 - Implicitly detached
11 - PLMN not allowed
12 - Location Area not allowed
13 - Roaming not allowed in this location area
14 - GPRS services not allowed in this PLMN
15 - No Suitable Cells In Location Area