Cisco Cisco ASR 5700
Local Policy Actiondef Configuration Mode Commands
▀ action
▄ Command Line Interface Reference, StarOS Release 17
6916
rulebase_name
must be an existing rulebase within this local QoS policy service expressed as an
alphanumeric string of 1 through 63 characters.
default-qos qci value arp value
Sets the default QoS parameters for the session
qci value
must be an integer from 1 through 254.
arp value
must be an integer from 1 through 15 (StarOS v12.1 and earlier) or 1 through 127
(StarOS v12.2 and later).
delete-bearer qci value arp value
Important:
This keyword is not supported in 16.0 and later releases.
Deletes a bearer.
qci value
must be an integer from 1 through 254.
arp value
must be an integer from 1 through 15 (StarOS v12.1 and earlier) or 1 through 127
(StarOS v12.2 and later).
event-triggers [ default-bearer-qos-change | qos-change ]
This action specifies to enable the event triggers – Default EPS bearer QoS change event trigger and
QoS change event trigger.
QoS change event trigger.
reconnect-to-server [ send-usage-report ]
Reconnects to the PCRF server to handle fallback scenario. That is, when the session falls back to
local policy, this action specifies to retry connecting to the PCRF server.
local policy, this action specifies to retry connecting to the PCRF server.
send-usage-report
: Triggers CCR-U with volume report immediately. The default behavior is
that the CCR-U will not be triggered immediately.
On timer-expiry, if the initial failure is due to CCR-U failure, and if
send-ccru-immediate
is
configured, then CCR-U will be sent with the usage report immediately.
reject-requested-qos
Rejects UE QoS resource request.
retry-count value
Retry action. This applies to start-timer/activate-rule/activate-ruledef.
value
must be an integer from 0 through 65535.
start-timer name duration value retry-count value
Starts a named timer. On expiry of this timer, the local policy engine is contacted to initiate the
appropriate action, such as termination of a session.
appropriate action, such as termination of a session.
duration value
: Enter a timer duration from 0 through 28800 seconds. A value of 0 can be used
to leave the local policy until the subscriber disconnects. Default timer value is 14400 (seconds).
retry-count
specifies the maximum number of times the server will be retried before terminating
the call.
retry-count value
must be an integer from 0 through 65535. Default retry count is 3.
stop-timer name
Stops the designated timer.