Cisco Cisco ASR 5700
MIPv6 HA Service Configuration Mode Commands
bind ▀
Command Line Interface Reference, StarOS Release 17 ▄
7153
bind
Designates the address of the MIPv6HA service and specifies the maximum number of subscribers that can access this
service over the interface.
service over the interface.
Product
PDSN
HA
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > MIPv6HA Service Configuration
configure > context context_name > mipv6ha-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mipv6ha-service)#
Syntax
bind address IPv6_address [ max-subscribers count ]
no bind address
no
Removes the bound address from the HA service.
address
Specifies the IPv6 address of the MIPv6HA service using IPv6 colon-separated-hexadecimal notation.
max-subscribers
count
Default: 3000000
Specifies the maximum number of subscribers that can access this service on this interface.
Specifies the maximum number of subscribers that can access this service on this interface.
count
is an integer from 0 through 4000000.
Important:
The maximum number of subscribers supported depends on the installed license key and the number
of active packet processing cards installed in the system. Refer to the
license key
command for additional
information.
Usage
Use this command to associate the HA service with a specific logical IP address. The logical IP address or
interface takes on the characteristics of a Pi interface. Only one interface can be bound to a service. The
interface should be configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
interface takes on the characteristics of a Pi interface. Only one interface can be bound to a service. The
interface should be configured prior to issuing this command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
max-subscribers
option, be sure to consider the following:
The total number of interfaces that you will configuring for use as Pi interfaces