Cisco Cisco Packet Data Gateway (PDG)
BITS Port Configuration Mode Commands
▀ recover
▄ Command Line Interface Reference, StarOS Release 17
1678
recover
Configures line-timing so the SPIO recovers timing from a port on an optical (OLC/OLC2) or channelized (CLC/CLC2)
card. The recovered clock is then distributed to synchronize timing on all line cards in the chassis.
card. The recovered clock is then distributed to synchronize timing on all line cards in the chassis.
Important:
To employ line-timing recovery, the SPIO card(s) must be equipped with the optional Stratum 3
clock module.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > BITS Port Configuration
configure > port bits slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
recover { line1 slot_number | line2 slot_number }
no recover { line1 | line2 }
no
Deletes the identified line-timing source definition from the configuration.
line1
slot
Sets first priority for line-timing clock recovered from the line card in the specified slot.
slot_number
is an integer between 1 and 48.
line2
slot
Sets second priority for line-timing clock recovered from the line card in the specified slot.
slot_number
is an integer between 1 and 48. This cannot be the same slot number entered for
line1
.
Usage
Define which line-timing source has priority.
Important:
If the SPIO is connected to an external Building Integrated Timing Supply (BITS) source, BITS
timing always takes precedence over line-timing.
Example
Configure the line card in slot 19 as the preferred source for line-timing.