Cisco Cisco Packet Data Gateway (PDG)
Context Configuration Mode Commands N-R
radius trigger ▀
Command Line Interface Reference, StarOS Release 17 ▄
2729
radius trigger
This command enables specific RADIUS triggers. The RADIUS Trigger configuration in the Context Configuration
Mode is to enable backward compatibility. To configure RADIUS triggers for the default AAA group, you must
configure them in the Context Configuration Mode.
Mode is to enable backward compatibility. To configure RADIUS triggers for the default AAA group, you must
configure them in the Context Configuration Mode.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
[ no ] radius trigger { ms-timezone-change | qos-change | rai-change | rat-change |
serving-node-change | uli-change }
serving-node-change | uli-change }
default radius trigger
no
Disables the specified RADIUS trigger.
default
Configures the default setting.
Default: All RADIUS triggers are enabled.
Default: All RADIUS triggers are enabled.
ms-timezone-change
Specifies to enable RADIUS trigger for MS time zone change.
qos-change
Specifies to enable RADIUS trigger for Quality of Service change.
rai-change
Specifies to enable RADIUS trigger for Routing Area Information change.
rat-change
Specifies to enable RADIUS trigger for Radio Access Technology change.