Cisco Cisco Packet Data Gateway (PDG)
DHCP Service Configuration Mode Commands
▀ dhcp server
▄ Command Line Interface Reference, StarOS Release 17
3454
dhcp server
Configures DHCP servers with which the DHCP service is to communicate.
Product
ASN-GW
eWAG
GGSN
HA
P-GW
SAEGW
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > DHCP Service Configuration
configure > context context_name > dhcp-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-dhcp-service)#
Syntax
dhcp server { ip_address | port port_num [ priority priority ]
no dhcp server ip_address
default dhcp port
default
Sets the default value of UDP port on DHCP server; 67 for DHCP messaging.
no
Deletes a previously configured DHCP server.
ip_address
Specifies the IP address of the DHCP server expressed in IPv4 dotted-decimal notation.
Important:
In the case of DeWAG service, this IP address must be the same as the IP address configured with
the
bind address
CLI command under the same DHCP Service Configuration mode.
port port_num
Specifies the port number to send DHCP messages to non-standard UDP ports of the server if multiple
servers are configured.
servers are configured.