Cisco Cisco Packet Data Gateway (PDG)
IMS Authorization Service Configuration Mode Commands
qos-update-timeout ▀
Command Line Interface Reference, StarOS Release 17 ▄
6501
qos-update-timeout
This command is obsolete in release 11.0 and later releases. This command sets the Quality of Service update timeout
for a subscriber in IMS authorization service.
for a subscriber in IMS authorization service.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IMS Authorization Service Configuration
configure > context context_name > ims-auth-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-imsa-service)#
Syntax
qos-update-timeout timeout_duration
no qos-update-timeout
no
Disables the pre-configured QoS update timeout parameter in this IMS authorization service.
timeout_duration
Specifies the duration of timeout in seconds as an integer from 0 through 3600.
Default: 60
Default: 60
Usage
Use this command to set the maximum time to wait for a subscriber to initiate the update QoS procedure in
IMS authorization service.
IMS authorization service.
Example
The following command sets the QoS update timeout to
90
seconds.
qos-update-timeout 90