Cisco Cisco Packet Data Gateway (PDG)
MPLS-LDP Configuration Mode Commands
router-id ▀
Command Line Interface Reference, StarOS Release 17 ▄
7339
router-id
Configures the Label Distribution Protocol Router ID.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > MPLS-IP Configuration > MPLS-LDP Configuration
configure > context context_name > mpls-ip > protocol ldp
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ldp)#
Syntax
router-id ipv4_addr
no router-id
no
Disables the router ID.
ipv4_addr
Must be an IPv4 address entered in dotted-decimal notation.
Usage
This command is used to configure the LDP router-id. This is an optional parameter. If the ID is not
configured, the largest operational loopback address is selected as the LDP router ID. If LDP has started, any
change will take effect only after disabling and enabling LDP.
configured, the largest operational loopback address is selected as the LDP router ID. If LDP has started, any
change will take effect only after disabling and enabling LDP.
Example
The following command sequence configures an LDP router ID:
router-id 10.2.3.4