Cisco Cisco Packet Data Gateway (PDG)
PCC-Condition-Group Configuration Mode Commands
event-time ▀
Command Line Interface Reference, StarOS Release 17 ▄
7589
event-time
This command defines a condition based on the event-trigger time as per the time specified by the named Time
definition (Timedef) configured for subscriber session in an IP-CAN session.
definition (Timedef) configured for subscriber session in an IP-CAN session.
Product
IPCF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PCC Service Configuration > PCC Condition Group
Configuration
Configuration
configure > context context_name > pcc-service service_name > condition group group_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-pcc-condition-group)#
Syntax
[no] event-time operator timedef_name
no
Removes the specified condition definition.
operator
Specifies how to logically match the information in the analyzed field.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
timedef_name
Specifies the name of the configured time definition (start and end timer of session) which is used for
evaluation with this PCC-Condition-Group for user traffic.
evaluation with this PCC-Condition-Group for user traffic.
timedef_name
must be a pre-configured Time definition in PCC-Service Configuration Mode.
Usage
Use this command to define a condition based on the start and end time defined in a Time Definition
configuration in PCC-Service Configuration Mode for user traffic in an IP-CAN session.
Event trigger in this command indicates a condition when the event-trigger time was as per the time specified
by the named Time Definition.
This command allows the operator to use configured time period as event trigger for this PCC-Condition-
Group.
configuration in PCC-Service Configuration Mode for user traffic in an IP-CAN session.
Event trigger in this command indicates a condition when the event-trigger time was as per the time specified
by the named Time Definition.
This command allows the operator to use configured time period as event trigger for this PCC-Condition-
Group.
Example