Cisco Cisco Packet Data Gateway (PDG)
ACS Ruledef Configuration Mode Commands
▀ bearer sgsn-address
▄ Command Line Interface Reference, StarOS Release 17
808
bearer sgsn-address
This command allows you to define rule expressions to match IP address of the SGSN (in acting as GGSN) / P-GW (if
acting as S-GW) in the bearer flow.
acting as S-GW) in the bearer flow.
Important:
In 8.1 and later releases, this command is deprecated and is replaced by the
command.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] bearer sgsn-address operator ipv4/ipv6_address
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
=
: Equals
ipv4/ipv6_address
Specifies the SGSN IP address to match.
ipv4/ipv6_address
must be in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation.
Usage
Use this command to define rule expressions to match IP address of the SGSN (in acting as GGSN) / P-GW
(if acting as S-GW).
(if acting as S-GW).
Example
The following command defines a rule expression to match user traffic based on SGSN node IP address
10.1.1.1
:
bearer sgsn-address = 10.1.1.1