Cisco Cisco Packet Data Gateway (PDG)
Route-map Configuration Mode Commands
▀ set local-preference
▄ Command Line Interface Reference, StarOS Release 17
8260
set local-preference
Sets the BGP local preference attribute that is sent by the BGP speaker only to IBGP peers.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Route-map Configuration
configure > context context_name > route-map map_name { deny | permit }
seq_number
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-route-map)#
Syntax
[ no ] set local-preference pref_number
no
Disables the specified local preference.
pref_number
Specifies the BGP local preference number as an integer from 1 through 16777214.
Usage
Sets the BGP local preference attribute that is sent by the BGP speaker only to IBGP peers. This value can be
used by peers to determine the exit point of the Autonomous System (AS).
There is no match clause corresponding to local preference in the route-map because local-preference is
directly used in the route selection algorithm.
used by peers to determine the exit point of the Autonomous System (AS).
There is no match clause corresponding to local preference in the route-map because local-preference is
directly used in the route selection algorithm.
Example
The following command sets the BGP local preference attribute to 33:
set local-preference 33