Cisco Cisco Packet Data Gateway (PDG)
S1AP Cause Code Configuration Mode Commands
▀ class
▄ Command Line Interface Reference, StarOS Release 17
8276
class
Configures a set of cause codes within a cause code group.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > LTE Policy Configuration > S1AP Cause Code Configuration
configure > lte-policy > cause-code-group
group_name
Entering the above command sequence results in the following prompt:
[local] host_name (s1ap-cause-code)
Syntax
[no] class { miscellaneous | nas | protocol | radio | transport } cause cause_no
no
Removes the specified cause code class.
miscellaneous
Specifies the class of miscellaneous cause codes.
nas
Specifies the class of NAS cause codes.
protocol
Specifies the class of protocol cause codes.
radio
Specifies the class of radio cause codes.
transport
Specifies the class of transport cause codes.
cause cause_no
Specifies the cause codes to add to this class. Cause codes must be defined one at a time.
cause_no
is a numeric cause code value, as defined in 3GPP TS 36.413.
Usage
Use this command to configure the specific cause codes within this S1AP Cause Code Group.
A maximum of 16 cause codes can be added to a cause-code-group entry.
A maximum of 16 cause codes can be added to a cause-code-group entry.